After a few seconds of activity, your PC will recognise the mbed Microcontroller as a standard USB drive. The status light will come on, indicating FRDM-KL25Z has power. Use the USB lead to connect your FRDM-KL25Z to a PC, using the USB female connector labelled OpenSDA. Connect your mbed-enabled FRDM-KL25Z to your PC The following connections will allow us to program the mbed board, and to prepare itįRDM KL-25Z board is going to communicate with Microchip’s TCN75A temperature sensor on Digilent Basic I/O Shield.Ģ. – JY-MCU Bluetooth Module (available from Aliatron) – Power supply unit (MB-102)for the set up
#KL25Z DRIVER FOR MAC BLUETOOTH#
If you done neither of the two above exercises, you ought to follow the introduction “Getting Started with mbed and Freescale FRDM-KL25Z board”.Īlso you must have done temperature measurement with temperatur sensor TCN75A on Digilent Basic I/O shield.Īnd Bluetooth adapter, Buletooth module and power supply unit: Tested FRDM-KL25Z with simple exercise such as blinking the RGB LED on it.Installation in Windows of your FRDM-KL25Z board.Remote viewing is an interesting proposition that we will dwell upon here with these two boards, and some extra material, such as a Bluetooth module and, at the end, Bluetooth-enabled phones. The Basic I/O Shield is designed to the same form factor as the Uno32 board, but is also usable with the FRDM-KL25Z board. A potentiometer is also provided for use as an analog input device. It provides more advanced devices such as an I2C EEPROM, an I2C temperature sensor, and organic LED graphic display. The Basic I/O Shield provides simple digital input devices such as switches and buttons, and digital output devices such as discrete LEDs and high current open FET drivers. The Digilent Basic I/O shield is an input/output expansion board designed for use with chipKIT microcontroller boards such as the Uno32™ and the Max32™. The FRDM-KL25Z is supported by a range of Freescale and third-party development software, including mbed platform. Features include easy access to MCU I/O, battery-ready, low-power operation, a standard-based form factor with expansion board options and a built-in debug interface for flash programming and run-control. The Freescale FRDM-KL25Z board is an ultra-low-cost development platform for Kinetis L Series KL1x (KL14/15) and KL2x (KL24/25) MCUs built on ARM® Cortex™-M0+ processor.
0 kommentar(er)
